Vivax V DESIGN ACP-12CH35AEVI GOLD, User Manual

Page: 160 / 216

Deflector
rod
Fig. 2.3
Setting Angle of Air Flow
Setting vertical angle of air flow
While the unit is on, use the SWING /DIRECT button to
set the direction (vertical angle) of airflow.
1. Press the SWING /DIRECT button once to
activate the louver. Each time you press the button, it
will adjust the louver by 6°. Press the button until the
direction you prefer is reached.
2. To make the louver swing up and down
continuously, press and hold the SWING/ DIRECT
button for 3 seconds. Press it again to stop the
automatic function.
Setting horizontal angle of air flow
The horizontal angle of the airflow must be set
manually. Grip the deflector rod (See Fig.2.3) and
manually adjust it to your preferred direction. For
some units, the horizontal angle of the airflow can be
set by remote control. please refer to the Remote
Control Manual.
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set louver at
too vertical an angle for long periods of time. This can
cause water to condense on the louver blade, which
will drop on your floor or furnishings. (See Fig. 2.2 )
When using COOL or HEAT mode, setting the louver at
too vertical an angle can reduce the performance of
the unit due to restricted air flow.
Do not move louver by hand. This will cause the
louver to become out of sync. If this occurs, turn off
the unit and unplug it for a few seconds, then restart
the unit. This will reset the louver.
Fig. 2.2
!
CAUTION
Do not put your fingers in or near the blower and suction
side of the unit. The high-speed fan inside the unit may
cause injury.
Caution: Do not keep louver at too
vertical an angle for long periods of
time. This can cause water
condensation to drip on your
furnishings.