24
www.vivaldigroup.it
CHANGE NAME page. By default, the name is VIVALDI_ (followed by an automatically generated alphanumeric
code). Use << and >> keys to move between the spaces. Use + and – keys to scroll characters and symbols. The
maximum number of characters/symbols is 13. Once done, press ENTER to confirm.
BOOT SETUP page on ADVANCED SETUP menu. In this page it is possible to configure the start-up parameters
of FREEmk3, FREENETmk3 and FREESOURCEmk3 Press ENTER key to access this section.
6.4.3 BOOT SETUP
BOOT SETUP page. FREEmk3, FREENETmk3 and FREESOURCEmk3 allow to set some parameters that will
be automatically performed whenever the power is interrupted. Use << and >> keys to move between the parame-
ters and pages. Use + and – keys to adjust the selected parameter. Once done, press ENTER to confirm and save
the settings.
STBY:
on YES, once the power is back after an interruption, FREEmk3, FREENETmk3 and FREESOURCEmk3
will be automatically put in stand by mode. on NO, once the power is back after an interruption FREEmk3, FREE-
NETmk3 and FREESOURCEmk3, will automatically set the source and volume level specified in the next options.
On LAST, the device will set the last source and volume level set before the interruption. Default value: YES.
VOLUME:
set the volume level at automatic startup after a power interruption. Values 0 to 50, if on LAST, the devi-
ce will set the and volume level set before the interruption. Default value: LAST.
SOURCE:
allows you to set the source where the FREEmk3, FREENETmk3, and FREESOURCEmk3, (when
STBY is set to NO). You can set any device source. If LAST, the device turns on in the source where it was when it
was turned off. Default: LAST.
NOTE: this function is only available if OC2 pin is disabled. OC2 EN: DISABLE (see Chapter 6.4.5)
