VITRA ACRYLIC SHOWER TRAYS, Installation And User Manual

Page: 10 / 12

MAINTENANCE OF THE SHOWER TRAYS
MATTERS THAT REQUIRE ATTENTION!
POSSIBLE PROBLEMS AND THEIR SOLUTIONS
Cleaning the Acrylic Shower Trays
Using the Siphon Key of the Shower Tray
10
1- To clean the dirt which accumulates inside the siphon you can use the siphon key found in the package provided together with
the shower tray.
2- Use the siphon key as shown in the picture in order to lift the siphon cover.
3- After lifting the inner chamber as shown in Figure 4, perform the required cleaning and replace the parts in their places.
• Right after you use your shower tray, clean it with a liquid bath cleaner or a decalcifier and a soft cloth and warm water.
Otherwise unwanted soap products, dirt and hard water will create a thin layer on the acrylic surface and it will become more
difficult to clean.
• Do not use hydrochloric acid, abrasives, powdered detergents and cream detergents that contain powders, soft soap and
hard/scratching cleaning sponges for cleaning your shower tray.
Note: When products with cabins, particularly patterned products are concerned, clean the glasses with a soft cloth and warm
water. Do not use hydrochloric acid, abrasive / powdered / liquid detergents soft soap or hard/scratching cleaning sponges.
Do not let organic dilutions, paint removers, acetone and other solvents contact the glass.
• Acrylic is durable against acids and alkalines. However do not let organic solutions used in dry cleaning, paint remover
substances, acetone or other solvents to your compact system.
• Keep lighted cigarettes away from the product.
• If the construction activities in the bath will continue after installation, do not remove the folio layer on the product and apply
full protection to the product.
• If your shower tray is new, the protective film layer on it might not have
been removed.
• If dullness/scratches occur after a certain period of use, you may be using
incorrect cleaning materials. See the 'Cleaning of Bathtubs with Massage’
section.
• Check if the Wall hangers are installed on the wall or not.
The wall hangers must be used in order to preserve the rigidity of the
shower tray.
• Check the silicone application between the shower tray and the wall
• Check the isolation of the cabin over the shower tray.
• Hair, soap, etc. could clog the siphon in time. Clean the siphon drain with a
drain opener from time to time.
If your problems persist please contact the nearest VitrA-Artema Authorized Service.
• The surface of the shower tray is dull
and/or scratched.
Problem Solution
• My shower tray stretches
• Water leakage under the shower tray
• The siphon drain of my shower tray clogs
frequently.