VITO PRO-POWER VIML65L, Instruction Manual

Page: 28 / 44

28
EN
Disconnect the probe and remove
all water from the hose.
Carefully wrap the hose making sure
that this does not become twisted.
Damaged hoses are dangerous
when under pressure.
With the engine off, and before stor-
ing the machine, place the fuel lever
in the OFF position as pictured
(photo 25-25.1).
setting sPray noZZle
(Photo 26)
Has four spray nozzles with differ-
ent colors giving effect to spray
different choice:
Sprinkler nozzle 0 ° (red): This
sprinkler emits a jet thin and
very strong. Covers a small area
cleaning. The rotor must only be
used on surfaces able to withstand
high pressures (such as metal and
concrete). Do not use wood.
Sprinkler nozzle 15 (yellow): this
sprinkler emits a jet of 15 º to
intense cleaning in small areas.
This spray should only be used on
surfaces capable of withstanding
high pressures.
Sprinkler nozzle 40 (white): this
emits a spray jet 40 for cleaning
which do not require high pressures.
Covers a wide area cleaning. It
can be used in virtually all types of
cleaning.
Low-pressure spray nozzle (Black):
This is used for spray application
of chemical cleaning solutions and.
Little pressure.
note:Before using your washer
in cleaning paving slabs, test a
small area first. Some paving slabs
are made with inferior materials
and high pressure can damage the
surface.
Connect the spray nozzle using the
quick attachment system, which
allows an exchange facilitated. To
fit the rotor, slide the metal collar
gun back (photo 26-26.1), place
the sprinkler in the dock (pictured
26-26.2). Loosen the metal collar
to attach the sprinkler.
To release it, slide the metal collar
back: the rotor can be removed.
use detergent (Photo
27)
Fill a container with detergent. Do
not use liquid dishwasher because
they contain salt.
We recommend using a good
detergent suitable for washing
machines. Follow the instructions on
the detergent.
Most detergents car is a combina-
tion of detergent with wax. These
tend to be viscous.
The viscosity increases at low
temperatures.
We recommend that this type of
detergent is diluted with warm
water before refilling. When using
detergents in combination with wax
recommend its dilution before use.
As a general guide, we recommend
diluting 50/50. However, an error
in the first test determines the exact
percentage of dilution.
notes: A viscous detergent does
not flow properly and deposit their
waste can block the system.
After using the detergent system, it
should be thoroughly cleaned using
water freely.
To activate the detergent system,
place the nozzle sprinkler black.
Immerse fishing detergent system
(photo 27-27.1) in the tank. Suction
and mixing will occur automatically
once the water flow at the pump.
clear a BlocK oF Filth
(Photo 28)
If at any time denote the water flow
decrease or fickle, release the trig-
ger and turn off machine. Squeeze
trigger to relieve the pressure and
make the jet at the end of the tip. If
you suspect a blockage in sprinkler
use tool cleaning jet. It is very
important that the water jet to be
checked and cleaned regularly using
the tool provided. Stop the engine
and disconnect the water before any
cleaning.