VITO PRO-POWER VIML65L, Instruction Manual

Page: 26 / 44

26
EN
Fill oil sumP (Photo 12
and 13):
imPortant: The engine is
shipped without oil so it must be
added before putting the machine
into operation.
Place the machine on a flat surface
and remove the meter (photo
12-12.1).
Add oil to the level indicated rod
(photo 13-13.1)
Filling the Fuel tanK
(Photo 14)
The washer has a 4tempos engine
using unleaded gasoline. Use a fun-
nel to transfer the fuel to the tank,
making sure it does not leak any
fuel or fill the tank too much. The
tank should not be filled above the
threshold as shown in photo 14
connecting hoses
(Photo 15-17)
attention: Use cold water
only.
The water inlet connector has a
particulate filter and this should not
be removed (photo 15-15.1)
This filter should not be removed
except for cleaning and examination.
The filter water inlet must be checked
and cleaned before each use.
Push the male connector (water in-
let at the entrance - photo 16-16.1).
A female connector fitting the water
inlet pipe and then into the male
connector.
Connect the pressure hose to the
outlet pipe (photo 17-17.1)
Turn on the water and squeeze the
trigger until there is a constant flow
of water outlet. Do not use water
hotter than 40 ° C.