Vitek VT-EH Series, Instructions Manual, Page: 28 / 81

VT-EH Series DVRs________________________________________________________________________________
28
S
S
Y
Y
S
S
T
T
E
E
M
M
S
S
E
E
T
T
U
U
P
P
SYSTEM NAME : It is used so that notification emails can be identified.
F/W UPGRADE : Firmware updates may be released periodically to enhance system performance and add extra features.
The operator can upgrade the firmware using a USB memory stick.
After inserting the F/W in USB, Press UPGRADE . Then the menu below will appear.
After selecting the F/W from F/W list, press UPGRADE .
FACTORY DEFAULT : This will set the unit back to factory settings.
SYSTEM DATA : System settings can be saved to a USB memory stick. The settings can be reloaded in case of
accidental factory reset or can be transferred to another DVR if multiple units need to be installed with
the same settings.
PASSWORD : Determines the PASSWORD ON/OFF to enter specific menu.
SYSTEM: CONTROL DEVICE
This will allow up to 254 DVRs to be controlled from the same keyboard.
SYSTEM ID : If more than one DVR is connected on the same RS485 bus, each one must have a unique ID.
Note : If using more than one DVR on stack, each DVR must have a unique ID for control by remote controller.
PROTOCOL : Must be set by Control Device.
BAUD RATE : Must be set to match the baud rate of the PTZ controller.