6
ENGLISH
•
Install the stationary nets into the shaving block; ensure
that nets are fixed; to fix the net turn it clockwise or
counterclockwise.
•
Insert the rotating blades into the stationary nets.
•
Install the locking frame, turn the frame clamp clockwise.
•
Install the shaving block on the shaver.
Attention!
You can wash the shaving block under a warm water jet
(pic. 9), if the shaving block (1) is detached from the shaver
body (3).
Dry the shaving block (1) thoroughly before installing it,
provide that water doesn’t get into the shaver body.
Trimmer
•
Clean the trimmer after each use.
•
Switch the shaver off.
•
Move the trimmer lock (7) downwards.
•
Clean the trimmer with the brush (10) supplied with the
unit.
•
Every six months lubricate the trimmer with a drop of oil
for sewing machines or hair clippers.
REPLACEMENT OF SHAVING HEADS
(pic. 7, 8)
For the best shaving results replace the shaving heads
every 2 years.
Replacement of shaving heads is performed as described
in chapter «CLEANING AND CARE».
•
Switch the shaver off.
•
Press the release button (2) and remove the shaving
block (1).
•
Turn the frame clamp counterclockwise and remove
the frame.
•
Replace the shaving heads, install the locking frame,
turn the frame clamp clockwise.
•
Install the shaving block (1) on the shaver.
Note:
After replacement of the shaving heads the fitting of
rotating blades to the nets will take some time.
DELIVERY SET
Men shaver – 1 pc.
Power cord – 1 pc.
Protective cap – 1 pc.
Cleaning brush – 1 pc.
TECHNICAL SPECIFICATIONS
Supply voltage: 220-240 V, ~ 50 Hz
Power consumption: less than 1 W
Rechargeable battery: Ni-MH 2/3 AA 600 mAh 2.4 V
IM VT-8268_70x130.indd 6
13.12.2017 18:07:36
