Vitek VT-1311, Manual Instruction

Page: 4 / 28

4
ENGLISH
•
The power cord should not:
–
touch hot objects;
–
run over sharp edges;
–
be used as a handle for carrying the unit.
• Regularly check the integrity of the power
cord.
• To avoid damages, transport the unit in the
original package only.
•
Do not use the unit if the power plug or the
power cord is damaged, if the unit works
improperly and after it was dropped. If
the power cord is damaged, it should be
replaced by the manufacturer, service or
similar qualified personnel to avoid danger.
•
Do not attempt to repair the unit. Do not dis-
assemble the unit by yourself, if any mal-
function is detected or after it was dropped,
unplug the unit and apply to any autho-
rized service center at the contact addresses
given in the warranty certificate and on the
website www.vitek.ru.
•
Keep the unit in a dry cool place out of reach
of children and disabled persons.
THIS UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY. ITS COMMERCIAL USAGE AND USAGE
IN PRODUCTION AREAS AND WORK SPACES
IS PROHIBITED.
USING THE HAIRDRYER
After unit transportation or storage at low
temperature it is necessary to keep it for
at least three hours at room temperature
before switching on.
•
Unpack the unit and remove any advertising
stickers that can prevent the unit operation.
Unwind the power cord completely.
• Before switching the unit on, make sure that
your home mains voltage corresponds to the
unit operating voltage.
•
Insert the power plug into the mains socket.
Switching hair dryer on
Before switching the appliance on make sure
power supply voltage meets operating voltage
of the appliance.
• Insert power cord plug into wall outlet.
• Select operating speed you need using air-
flow speed switch (7):
0 = the hairdryer is switched off;
= low speed;
= high speed.
• Select airflow temperature you need using
heating degree switch (6).
= slight heating
= medium heating
= maximal heating
= Cool shot function, press and hold the
cool shot button for fixing your hairstyle.
Taking care about your hair
Before drying and setting your hair, wash them
with shampoo, dry with towel to remove exces-
sive moisture and brush for better results.
Fast drying
Set switch (6) into position of maximal heating
(position ), select airflow speed you need us-
ing switch (7) and dry your hair out a little bit.
Shake off excessive moisture by hand or using
a brush and continuously move the hair dryer
over your hair.
Straightening your hair
Set switch (6) into position of maximal heat-
ing (position
), select airflow speed you
need using switch (7) and dry your hair out a
little bit. When your hair are almost dry, install
concentrating nozzle (1), reduce degree of
air heating by switch (6) and airflow speed by
switch (7).
Divide your hair in locks and layers, and start
straightening them from lower layers upwards.
Bruch hair downright using round or flat brush,
simultaneously directing hot air blowing from
concentrating nozzle on them. Straighten each
lock from root to tip this way. After you have fin-
ished straitening locks of the lower layer, start
processing the locks of medium layer, and so
on, and finish with straitening locks of the up-
per layer.
Natural waving structure of your hair
Set switch (6) into position of slight heating (po-
sition ), then set switch (7) into position , hold
a lock between your fingers tightly, turn it to di-
rection of its natural curliness, then dry the lock
out by directing air jet between the fingers. Af-
ter getting the shape you need, press cool shot
button (4) and fix each lock.