Installation Instructions - VTD-VD4MZ39
1. Locate the mounting template at the installation position and drill the ceiling or
wall if needed.
2. Open the dome cover by loosening screws (.16 x .47” / 4 x 12mm).
Use the torque wrench supplied.
4. Set the camera’s viewing angle and focus.
5. Put the dome cover on the dome base unit and tighten the assembly screws.
- Place the dome base unit on pre-drilled position and attach it through using
mounting screws (16 x 1.18” / 4 x 30mm).
- Route the Power & Ethernet cable to the connecting place.
- Place the surface mount on a pre-drilled position and attach it through using
mounting screws(.16 x 1.18” / 4 x 30mm). Assemble the cable pipe,
otherwise tighten a pipe hole cap with PM screw (
.1 x .24” / 2.6 x 6mm)
.
- Route the Power & Ethernet cable to the connecting place.
- Affix the dome base unit to the surface mount using the assembly screws
(
.16 x .55” / 4 x 14mm)
. Before securing the dome base make sure the assembly
holes are aligned with the surface mount assembly holes.
A. Flush mount type:
B. Surface mount type:
Assembly Screw
Torque Wrench
Assembly Screw
Mounting Screw
A
Flush mount type
B
Surface mount type
(.16 x .55” / 4 x 14mm)
(.16 x .47” / 4 x 12mm)
(16 x 1.18” / 4 x 30mm)
11
Summary of Contents for VIRTUOSO VTC-CB4MZ39
Page 42: ...NOTES 42...
