CONFIDENTIAL
– This document is property of VITEC MULTIMEDIA, and may not be used or diffused to a third party without prior written approval.
LW Player User Guide v2.6
page 48 / 70
7.8.
Genlock
Set Up Genlock
-
Plug SAC012 cable to the middle pins of J4 connector on the master board. The middle pins
provide Y-component signal, which can be used for genlocking of a slave board.
-
Plug the cable to J1 connector of the slave board.
-
If there is a next slave board use JP2 connector of the genlocked board to pass through the
genlock signal.
-
Plug a 75Ohm terminator to JP2 of the last board in the chain.
-
Open PlayerLWm application.
-
Select configuration of the slave board.
-
Open [PLAYER CONFIGURATION]
-
Choose [Edit Configuration]
-
Expand [Device] in LW Setting Page.
-
Expand [Genlock Control Settings].
-
Set Clock Reference to Genlock Input.
-
Close LW Setting Page.
-
Choose configuration of the other slave board in the list Preview Window (page 33 (3)).
Repeat setting procedure for the board.
-
When the boards are configured restart the PlayerLWm application.
Set Up SDI Synchronisation
SDI-Input of the board can be used to synchronize the board by external SDI signal.
It requires when the HD-SDI OUTPUT is set to 3G modes (1080p50/59.94 or 60).
-
Plug SDI cable to HD-SDI output of the Master board.
-
Plug the SDI cable to SDI input of the Slave board.
-
Select configuration of the slave board in Preview Window.
-
Open [PLAYER CONFIGURATION]
-
Choose [Edit Configuration]
-
Expand [Device] in LW Setting Page.
-
Expand [Genlock Control Settings].
-
Set Clock Reference to SDI Input.
-
Close LW Setting Page.
Use SDI repeater to synchronize more than one slave board.
-
Plug HD-SDI output of the Master board to SDI-IN of the repeater.
-
Use the outputs of the repeater to synchronize the slave boards.
-
Configure Clock Reference of every slave board to SDI-Input.
Check Genlock Status
