V I T A E a s y s h a d e
3
Easyshade is now ready to be calibrated. Calibration is required each time you power-up the unit, or each time
you apply an Infection Control Shield, but not required between each measurement.
CAUTION:
Do not calibrate Easyshade with an Infection Control Shield that has been in contact with a patient.
A new Infection Control Shield must be applied before calibration.
If a used Infection Control Shield makes
contact with the calibration block, then the calibration block and retainer must be removed from the
base unit for cleaning, disinfecting and sterilizing as described in Section 8.
1.3 Selecting Power-on Defaults
When the Easyshade is warming up, the bottom of the screen displays a “Presets” selection box. Touching
“Presets” allows the Easyshade’s default mode of operation to be selected and saved. Once the default mode
of operation is selected, it should rarely if ever needed to be changed.
Touching “Presets” on the warm-up or calibration screen causes display of the following screen:
This screen allows adjustment of the volume of the warning signals (“Beeps”), the brightness of the display
screen, and the timeout of the light source by touching the decrease (“<<”) or increase (“>>”) indicators.
Touching “Exit & Save” causes the changes to the settings (if any) to be saved as the power-on defaults. The
factory default settings are volume and brightness at maximum and Lamp Timeout at 5 minutes. Touching
“Next” causes the following screen to be displayed:
Summary of Contents for Easyshade
Page 45: ...V I T A E a s y s h a d e 44 ...