4
Blending Station
®
Advance
ON/OFF Power Switch –
Located on the side of the motor base, the ON/OFF switch
controls the power to the machine. While plugged in, switch to ON to ready the machine for
blending. Shut OFF the power switch at night or whenever the machine will be left unattended.
START/STOP Button –
Pressing START/STOP once starts and runs the machine and turns
the blade. Press the START/STOP button again to stop the machine and the blade.
SPEED CONTROL Button –
Press the
▲
button to gradually increase the speed of the
blade in increments of 1%, up to 100%. Press the
▼
button to gradually decrease
the speed of the blade in increments of 1%, down to 7%. SPEED CONTROL is used to set
the blending speed of the PULSE buttons (see Instructions, page 18) and the START/STOP
button (see Instructions, page 17).
PRE-SET PROGRAM Buttons –
These buttons, numbered 1 thru 6, are pre-programmed
blending cycles designed for the most commonly made drinks. Depending on the viscosity
of the drink you are creating, pressing one of the six PRE-SET PROGRAM buttons will run
the machine for a full cycle. The machine will stop by itself when the cycle is complete. A
cycle varies in speed and length; see the Instructions on page 16 for a complete description
of the range of each PRE-SET button. Each button can be reprogrammed to any of the 34
available recipes. See pages 8-11 for information on Custom Programming these six
buttons. Due to the difference of recipes, your results may vary.
Start/Stop
Speed Control
Pre-Set Programs
Owner Controls
High/Low Pulse
Display Window
