Visual Circuits H-DVP, User Manual

Page: 48 / 89

Registry Editing
38
component = REG_DWORD 0x0
1 for component video, 0 for RGB. (Can be overridden on a
channel by channel basis using the mpgSetVideoType function.)
DisableCCSync = REG_DWORD 0x0
1 to disable cross channel synchronization, 0 to enable (default 0.)
(Multi-channel servers only.)
DisableSync = REG_DWORD 0x0
1 to disable audio video synchronization (“lip sync”), 0 to enable
(default 0.)
fJitter = REG_DWORD 0x6400
This value, along with bJitter, help control the tolerance for A/V
sync.
freeTime = REG_DWORD 0x0350
This value, along with syncTime, controls the relative time
between periods in which the Video Decoder chip is instructed to
perform an A/V sync. If a file gets out of sync over time, try
lowering this value. A value too low will hinder the performance
of playback, however.
LoopType = REG_DWORD 0x00
This value indicates the type of looping between files that the
driver will do. 0 indicates a “smooth” loop, in which the start of
the second file is started immediately after the first file. 1 indicates
a “slow” loop, in which the second file will wait for the first file to
end completely before starting. This results in a slight pause
between files, but may eliminate some jitter or pixelization that
may happen with the first type of looping. (Can be overridden on a
channel by channel basis using the mpgSetLoopType function.)