Vista ViP2 VK2-1080VFD, Installation And User Manual

Page: 16 / 66

16
3.3 Access from the internet
The VK2-1080VFD is accessible on your local network (LAN). To access the camera from the Internet
you must configure your broadband router to allow incoming data traffic to the camera. To do this,
enable the NAT-traversal feature, which will attempt to automatically configure the router to allow
access to the camera. This is enabled from Setup > System > Network > NAT.
For more information, please
see “System>Network>NAT” of User’s Manual.
3.4 Setting the admin password over a secure connection
To gain access to the product, the password for the default administrator user must be set. This is
done in the “Admin Password” dialog, which is displayed when the VK2-1080VFD is accessed for the
setup at the first time. Enter your admin name and password, set by the administrator.
Note:
The default administrator username and password is “admin”. If the password is lost, the VK2-
1080VFD must be reset to the factory default settings. See
“Resetting to the Factory Default Settings”
for more details.
To prevent network eavesdropping when setting the admin password, this can be done via an
encrypted HTTPS connection, which requires an HTTPS certificate (see note below).
To set the password via a standard HTTP connection, enter it directly in the first dialog shown below.
To set the password via an encrypted HTTPS connection, see
“System > Security > HTTPS”.
Note:
HTTPS (Hypertext Transfer Protocol over SSL) is a protocol used to encrypt the traffic between
web browsers and servers. The HTTPS certificate controls the encrypted exchange of information.