Vista ViP2 VK2-1080VFD, Installation And User Manual

Page: 12 / 66

12
2.3 Connection
• Connecting to the RJ-45
Connect a standard RJ-45 cable to the network port of the VK2-1080VFD . Generally a
cross-over cable is used for directly connection to PC, while a direct cable is used for connection
to a switch or hub.
• Connecting Alarms
AI(Alarm In) :
You can use external devices to signal the VK2-1080VFD to react on events. Mechanical or
electrical switches can be wired to the AI (Alarm In) and G (Ground) connectors in the bottom.
G(Ground) :
Connect the ground side of the alarm input and/or alarm output to the G (Ground) connector.
Alarm Out :
The VK2-1080VFD can activate external devices such as buzzers or lights. Connect the device
to the AO (Alarm Out) and G (Ground) connectors.
• Connecting Video Output for set up only
Video Output is used for an easy zoom and focus
control when commissioning the camera. Set Video
Switch (SW2 on the board) to On position to output
the video signal. Video Output is restricted to
VGA(640x480) resolution.
Connect your Video cable unit to J5 on the board, as
shown on the adjacent illustration.
Caution: After the camera has been focused, you must set Video Switch SW2 to the OFF
position to provide the best performance of the VK2-1080VFD .
• Connecting the Power (If not using PoE)
Connect the power of 12VDC 330mA for the camera. C
onnect the positive (+) pole to the ‘+’
position and the negative (-
) pole to the ‘-‘position.