4. Programming
26
D-307083 PowerMaster-360R Installer's Guide
4.4.7 Defining configuration defaults for
device settings
PowerMaster-360R enables you to define the
default parameters
used during enrollment and to change them
whenever you wish so that new devices enrolled into the system will be configured automatically with these default
parameters without the need to modify the configuration of each new enrolled device. You can use a certain set of
defaults for certain group of devices and then change the defaults for another group.
IMPORTANT:
Devices that were already enrolled in the PowerMaster-360R system before the defaults have been
changed will not be affected by the new default settings.
To
Define
the Default parameters of a device Group proceed as follows:
Step 1
Step 2
Step 3
Step 4
Step 5
Select DEFINE
DEFAULTS Option
[1]
Select the respective
device Group
[2]
Select the Default
Parameter
[3]
Select the new
Default Setting
[4]
[5]
02:ZONES/DEVICES
CONTACT
SENSORS
DEFINE DEFAULTS
MOTION SENSORS
Alarm LED
Event Counter
Disarm Activity
Low
High
See
[5]
to
Step 3
– Changing Defaults
[1] Enter the
Installer Mode menu
, select the 02.ZONES/DEVICES
option (see section 4.2) and then select the
DEFINE DEFAULTS option.
[2] Select the respective Group of the device you wish to define its defaults. For example,
MOTION SENSORS
.
[3] Scroll the parameter list of the Device Group and select the Default Parameter you wish to change, for example:
Event Counter
. The list combines the parameters of all devices in the group, for example, the parameters of
all types of Motion sensors.
[4] In the example, the existing default setting of the Event Counter for enrolled motion sensors was
Low Sensitivity (marked with
) . To change it to
High
, scroll the menu until the display shows
High
and press
the
button. The new default for the Event Counter parameter setting of Motion Sensors enrolled from
now on will be
High
.
[5] The new default does not affect motions sensors that were already enrolled before the change was made but only
new motion sensors that will be enrolled in the PowerMaster-360R after the change is performed.
4.4.8 Updating devices after exiting installer mode
When exiting the
Installer mode
, the PowerMaster-360R panel communicates with all devices in the system and
updates them with the changes that have been performed in their Device Settings configuration. During the updating
period, the display indicates
DEV UPDATING 018
where the number (for example, 018) is a countdown of the
remaining number of devices yet to be updated.
