Page 38 of 72
Backup function
Make sure to select the intended Backup Mode prior the formal use of the
Normal Mode
Make sure to select the backup drive prior to the backup.
Click on Utility, then Option setting, and finally the Backup tab (Figure 20).
Click the down arrow in the backup drive box to display the available
removable drive(s) for backup and select the desired backup drive.
The removable device can be a DVD-RAM drive or a removable IDE hard
drive.
The user can choose to keep copies on hard disk after backup or not.
Click Apply to confirm and click OK to close the dialog box.
Archive Mode
Figure 20
Figure 21
Swap
Drive
Red
– Indicate the Drive is set Active, being used for immediate video recording
Green
– Indicates the Drive is dismounted, ready for physically taken out
VisionNet SW-80 User Menu
SW-80 system for routine video recording.
The system is set to "Normal" backup mode as system default. To switch to
"Archive" mode, check the bullet option next to Archive, then Apply and
OK. The SW-80 application should closed and restarted to effect the change.
At the start up on Archive backup mode, the main screen of the SW-80 will
be slightly modified and refreshed as shown in figure 21.
Summary of Contents for SW-80
Page 1: ...VisionNet Technology VisionNet Network DVR SW 80 User Manual...
Page 50: ...Page 49 of 72 VisionNet SW 80 User Menu This is a blank page...
Page 51: ...Page 50 of 72 VisionNet SW 80 User Menu This is a blank page...
Page 52: ...Page 50 of 72 VisionNet SW 80 User Menu This is a blank page...
