Virginia Controls, LLC
MH-3000 User Manual, 1_03C10-VC
Page 90
properly. This feature can be turned off to disable the Oil Temperature Sw if it was
supplied, but is not required. The feature “
Enable Low Oil Switch or Oil Temp Feature
”
must also be turned on, if provided. With the feature enabled, if the Oil Temp Sw input
goes off, due to excessive temperature, then the car will shut down. The fault is reset by
energizing the Fault Reset Input, or by turning on Switch 4 on the CPU Dip Sw block.
•
Enable Low Oil Switch or Oil Temp Feature
–
Turn on to enable the Low Oil Sw OR
the Oil Temperature check feature. The separate feature for the Low Oil Sw or Oil
Temperature Sw must also be turned on to enable that specific feature.
•
Enable Oil Viscosity Feature
–
Turn on to enable Oil Viscosity operation. The input
for this feature must have been assigned for this feature to work properly. This feature
can be turned off to disable the Oil Viscosity feature if it was supplied, but is not
required.
•
Enable Rear Door Open Output
–
Turn on to enable the Rear Door Open output at
point 8 on the first output board.
•
Enable RD (RearDoor) Output
–
Turn on to enable the RD output at point 8 on the
first output board. This is used with front and rear doors only.
•
Enable 1UL - 4DL Hall Lantern Outputs
–
Turn on to enable specific Hall Lantern
outputs. The outputs for this feature must have been assigned for this feature to work
properly.
•
Enable Nudging Output
–
Turn on to enable the Nudging Output. This is not required
for Nudging Operation, as the Nudging Buzzer output is the only output specifically
required. The output for this feature must have been assigned for this feature to work
properly.
•
Enable CKO Output
–
Turn on to enable the CKO, Car Call Cutout Override, output.
The output for this feature must have been assigned for this feature to work properly.
•
Enable PI Blanking Fire Output
–
Turn on to use the Fire Light output as a Position
Indicator Blanking output.
•
Disable Door Close on Inspection
–
Turn on to prevent the Door Close output from
energizing on Inspection. This would require the doors to be closed manually. If this
feature is left disabled, the Door Close output will energize when the operator attempts
to run the car on Inspection.
•
Enable False Down Leveling on Car Fire Service
–
Turn on to allow the car to False
Down Level when it stops between floors, on Fire Service Phase 2. False Down Level is
used to return a car to a landing if it stops outside the door zone. The default is to
disable False Down Leveling on Fire Service Phase 2, so that the car will only run when a
car call is registered. If this feature is enabled and the car is on Fire Service Phase 2,
and the Stop Switch has been opened then closed, then a car call button must be
pressed to initiate False Down Level.
•
Enable Short Leveling Lockout on Down Run
–
Turn on to make the Leveling
Lockout Timer trip after one second for a Down Run, but after the custom set time for an
Up Run. This allows the Leveling Switches and Door Zone Input to be checked sooner in
the down direction.
•
Enable Flashing Hall Fire Light
–
Turn on to make the Hall Fire Light flash if the
Machine Room Smoke Sensor has tripped. By default the car Fire Light will flash, but
not the hall Fire Light.