18
© 1998 Directed Electronics, Inc. Vista, CA
N438 7/98
OPERATING-SETTINGS LEARN ROUTINE™
Many of the operating settings of this unit are programmable. They can be changed whenever necessary through
a computer-based Learn Routine
™
. In order to access Learn Routine
™
, the jumper underneath the sliding door on
the module must be in the learn position (see page 9). The Valet
®
/Program push-button switch, plugged into the
blue port is used together with a programmed transmitter to change the settings. To program settings remember:
Door, Key, Choose, Transmit and Release.
1. Door
Open a door. Either the H1/5 green or the H1/7 violet door trigger
wire must be connected for the control unit to “see” an open door.
2. Key
Turn the ignition on and then back off. The H1/9 yellow
switched ignition input must be connected.
3. Choose
Within 15 seconds, press and release the Valet
®
/Program button
the number of times corresponding to the number of the
desired feature (see the chart below). The one chirp settings
below are the factory default settings, except where indicated by
bold text.
Feature Number
One-chirp setting
Two-chirp setting
1
Active arming
Passive arming
2
Arm/disarm chirps on
Arm/disarm chirps off
3
Ignition-controlled door locks
Standard door locks
4
Active locking only
Passive locking
5
Panic with ignition on
No panic with ignition on
6
0.8 second door lock pulses
3.5 second door lock pulses
7
Forced passive arming on
Forced passive arming off
8
Automatic engine disable on
Automatic engine disable off
9
VRS
®
enabled
VRS
®
disabled
10
Code Hopping™ on
Code Hopping
™
off
11
Siren
Horn honk
12
Standard unlock pulse
Double unlock pulse
