Viper 50000584, Instructions For Use Manual, Page: 14 / 85

INSTRUCTION FOR USE ENGLISH
12
SOLUTION OR WASHING WATER TANK
FILLING
1.
Open the water inlet cover (A, Figure 5).
2. Fill with water or solution suitable for work
performance.
The solution temperature must not 104F
(+40°C).
3. Do not overfill the tank, refer to water level
indicator (B, Figure 5) for the water volume.
B
A
Figure 5
REGULATING WATER FLOW
The volume of the water flow may be adjusted through the ball valve
handle (A, Figure 6) according to the amount of water required for
your scrubbing application.
Figure 6
A
MACHINE START AND STOP
Starting the machine
1. Prepare the machine as shown in the previous paragraph.
2. Push the machine to the area to be cleaned, by pushing it with the hands on the handlebar (D, Figure 7).
3. Lower the brush/pad-holder deck (I, Figure 7) and the squeegee (H) by lifting the pedal (G).
4. Press the power switch (A, Figure 7) to the “I” position.
5. Press the solution switch (B, Figure 7) to the “I” Position. (Work simultaneously with the safety switch (E) to control the solenoid
valve.)
6. Press the vacuum switch (C, Figure7) to the “I” position.
7. Start cleaning by pushing the machine with the hands on the handlebar (D, Figure 7) and pressing the safety switch lever (E, Figure
7).
WARNING!
Use only low-foam and non-flammable detergents, intended for automatic scrubber applications.
WARNING!
Regulating the ball valve handle (A, Figure 6) must be done under the condition when the power switch (39,
Figure 2) is in the “OFF” position.
Figure 5
Figure 6