Manual VIPA TM-E
Chapter 2
Hardware description
HB39E - TME - RE_900-1E650 - Rev. 09/11
2-3
Structure
[1] LEDs
[2]
RJ45 Ethernet interface
[3] not
used
[4] Reset
button
[5]
RS485 MPI interface
[6]
DIP switch MPI interface
[7]
Connector for DC 12...24V
power supply
[8]
Connector for digital I/O
[9]
Slot for GSM SIM card
[10]
SMA antenna jack
with male thread
1
2
3
5
4
7
8
6
10
9
At the front-side of the TM-E module there are two rows of LEDs. The
following table shows you the usage of the LEDs and the according colors:
Label
Color
Meaning
POWER
green
Power supply is active.
USER
green
blinks: The TM-E module is ready for
communication (ca. 20s after PowerOn)
red
blinks: IP address not valid (just exist)
red/green blinks alternating: The TM-E module is just
waiting for an IP address during boot-up.
The LED is also used with the Reset.
More about this may be found at "TM-E - Reset".
Serial
green
blinks: The TM-E module is communicating with
the PLC via MPI.
MDM
green
on: The modem of the TM-E module is physically
connected.
LINK
green
on: The TM-E module is physically connected to
Ethernet.
ACT
green
blinks: The TM-E module communicates via
Ethernet (activity).
DI
green
on: The digital input of the TM-E module is "1".
POWER
SERIAL
LINK
DI
USER
MDM
ACT
DO
DO
green
on: The digital output of the TM-E module is "1".
TM-E GSM/EU
Components
LEDs
