VIPA SLIO 001-1BA00, Manual, Page: 18 / 48

Chapter 1 Basics and Assembly
Manual VIPA System SLIO
1-10 HB300E - PS-CM - Rev. 11/28
Demounting and module exchange
With demounting and exchange of a module, head module (e.g. bus
coupler) or a group of modules for mounting reasons you have always to
remove the electronic module of the just mounted right module. After the
mounting it may be plugged again.
For the exchange of an electronic module, the electronic module may be
pulled forward after pressing the unlocking lever at the lower side of the
module.
For installation plug the electronic module guided by the strips at the lower
side until this engages audible to the terminal module.
1. Press
2. Pull
Clack
1 2 3
•
Remove if exists the wiring. More about this may be found at "Wiring".
•
Press the unlocking lever at the lower side of the just mounted right
module and pull it forward.
•
Turn the locking lever of the module to be exchanged upwards.
•
Pull the module forward.
1
2 3
Proceeding
Exchange of an
electronic module
Exchange of a
module