Chapter 4 Deployment
Manual VIPA Accessories
4-8
HB37E - IM - RE_306-1LE00 - Rev. 09/28
DP-V0 slave parameterization
Via a double-click on the placed DP-V0 slave its parameter dialog may be
accessed. Here module specific data may be read or changed.
In the following these parameters are described.
Order number and GSD file name of the IM 306 DP slave.
Shows the DP slave family
As DP slave type the order number added with DPV0 is shown.
The designation is generated by the system and may be changed at any
time.
This is a diagnostics address generated by the system, which may be
changed at any time. Failure and return of the DP slave is reported to the
master by means of this address.
The Profibus interface of the DP slave may be accessed via this button.
Here you may assign a Profibus address to the DP slave and you may
change the properties of the corresponding subnet.
If you have already assigned a Profibus address to the DP slave, the
address appears beside the button.
Information about the DP master system, to which your slave is connected,
may be found below the button.
The SYNC- and FREEZE control commands of the master are supported
by the IM 306 DP slave from VIPA.
The DP master sends the
SYNC
control command to a group of DP slaves
causing the DP slaves to freeze the states of their outputs at their current
value.
The current state of the inputs is freezed by the
FREEZE
control command.
Calling the
parameter dialog
General
Module
Order number
GSD file
Family
DP slave type
Designation
Addresses
Diagnostic address
Node/
Master system
[Profibus...]
SYNC/FREEZE
capabilities