VIPA CP143 TCP/IP, Manual

Page: 92 / 210

The base file CP143
H1 / TCP/IP manual
5-12 Rev. 00/07
Transferring the base file
The following points must be noted when base data is transferred between a CP and a PC:
•
Communication parameters must have been set in Online.
•
A transfer is only possible when the PLC is stopped (STOP status). Please ensure that
your PLC has been STOPped.
•
You can only overwrite the data on the CP if the CP does not contain an EPROM.
For the transfer you may select a base file from one of the following 4 source / destination
combinations:
[Dbase
→
→ →
→
CP]
You are presented with a file selection window. Select the base file for the transfer. This will
be transferred to the CP.
[CP
→ → → →
Dbase]
The data base is located in the CP from where it is transferred to a file. Enter a file name into
the file selection window.
[NCS
→
→ →
→
CP]
All connections that have been entered into the connection masks of NCS are transferred
directly into the CP.
[CP
→ → → →
NCS]
The data base is located on the CP from where it is transferred directly into the connection
masks of the NCS.
[CP
→ → → →
FLASH]
The data base is located on the CP from where it is transferred directly into a flash-EPROM.
This function is only available from revision level 20 and firmware level V116.