VIPA CP143 TCP/IP, Manual

Page: 186 / 210

Example CP143
H1 / TCP/IP manual
6-26 Rev. 00/07
6.4.5 Module configuration under TCP/IP
The configuration for station 1 and 2 differs only in the respective parameters. The method is the
same. The following steps show how both stations must be configured. The parameters for each
station must be set individually.
To configure the two stations you must please perform the following steps:
•
Construct a network as per Fig. 6-8.
•
If you have not yet installed the configuration software, do so now. The installation
procedure and instructions on how the program should be started are available from
chapter 5.
•
Generate the base data and transfer these into the CP
1. Start the program and initialize the CP
2. Check transport parameters and change where necessary
3. Configure the connection
4. Save base data
5. Transfer the base data to the CP
Re: 1. Start the program and initialize the CP
A window with data is displayed after the program has started. This window contains information
on the version no. This you will need for future enquiries from our Hotline.
Fig. 6-16: Start-up screen of the configuration program
Press any key to access the main menu. From the menu item Init select CP-Init and the CP
initialization window will be displayed.
The description of the configuration for both stations follows.
Every station must be configured individually. Please enter the data for station 1, save the data and
transfer it to station 1.
Now you must perform the same steps for station 2.