64
VK2-600PTZ User manual
• DOME RESET
Use the
Joystick
to move the cursor and right or
(IO/FN)
to accept selection.
DOME RESET
ARE YOU SURE ?
CANCEL
OK
This feature is used to re-calibrate the orientation of a selected dome camera. Origin offset value
is not affected by this function. (Offset is still valid after origin set.)
• SYSTEM MENU
Use the
Joystick
to move the cursor, right to select sub menu (if applicable) and
(Tele/Wide)
to
adjust. To save changes highlight ‘SAVE AND EXIT’ and move
Joystick
right.
Joystick
left
exits without saving.
SYSTEM MENU
MOTOR SETUP
PASSWORD EDIT
ORIGIN CHECK
CALIBRATION : OFF
PASSWORD ENABLE : ON
MENU TIME OUT : OFF
BLINK CURSOR : ON
DOME ANSWER : OFF
SAVE AND EXIT(ESC TO CANCEL)
CALIBRATION
: ON (Auto origin check) / OFF
PASSWORD ENABLE
: ON (requires the password to enter menu) / OFF
MENU TIME OUT
: ON (5minutes) / OFF (menu always on)
BLINK CURSOR
: ON / OFF (no blinking cursor)
DOME ANSWER
: ON / OFF (no acknowledge command from the dome.
This option should be left OFF unless the
keyboard/DVR/controlling device and or Protocol
specifically asks for it to be switched ON.
MOTOR SETUP
Use the
Joystick
to move the cursor and
(Tele/Wide)
to adjust. To save changes highlight
‘SAVE AND EXIT’ and move
Joystick
right.
Joystick
left exits without saving.
MOTOR SETUP
PROPOTIONAL P/T : ON
P/T MODE : NORMAL
SAVE AND EXIT(ESC TO CANCEL)
