62
VK2-600PTZ User manual
4. Select ‘SWAP’. Set to ON, to swap the start RIGHT & LEFT LIMITS - adjust with
(TELE/WIDE)
5. T
o save changes highlight ‘SAVE AND EXIT’ and move
Joystick
right.
Joystick
left exits
without saving.
NOTE:
The Dome needs to be under the 90 degree vertical. When the flip mode is 90
, 100
,
110
or 120
and you move over 90
vertically, the panning range operates on the
opposite side.
• INITIALIZE DATA
Use the
Joystick
to move the cursor, right to select sub menu (if applicable) and
(Tele/Wide)
to
adjust. To save changes highlight ‘SAVE AND EXIT’ and move
Joystick
right.
Joystick
left exits
without saving.
INITIALIZE DATA
FACTORY DEFAULT
ERASE PROGRAMMED DATA
PRESET FOCUS DEFAULT
EXIT(ESC TO EXIT)
FACTORY DEFAULT
Select ‘FACTORY DEFAULT’ to initialize the Data.
Use the
Joystick
to move the cursor and right or
(IO/FN)
to accept selection.
FACTORY DEFAULT
ARE YOU SURE ?
CANCEL
OK
ERASE PROGRAMMED DATA
Use the
Joystick
to move the cursor and
(Tele/Wide)
to adjust. To save changes highlight
‘SAVE AND EXIT’ and move
Joystick
right.
Joystick
left exits without saving.
Erase all stored data from the Flash-ROM of the selected dome camera. You will be asked
to enter ON or OFF. If you desire to erase all data then select ‘ERASE’ run, otherwise press
the
(IC/FF)
key to exit without erasing. The erased data includes all stored data (Auto Scan,
Preset, and Tour etc ….) except origin offset. The offset value is still valid after all data is
erased. The offset value can be zero with default set of Offset origin menu.
