VIP Vision Residential IP Intercom Installation Guide - v1.3 Issued April 2017
24
3.
Select “VTO Set”. Change the “Main_VTO
Name”, to a name of your choice, for
example “Front Gate”.
4.
Change the IP address, of the Main VTO
to the IP address that was set on the Door
Station, in this example the IP address is
10.1.1.110
.
5.
Ensure “Enable Status” is set to “ON” for
the “Main_VTO”.
2. Select “Wired IP”” and change the IP
address, subnet mask, and default
gateway to match your local computer
network. Press “OK” to save.
In this example, we are going to change the IP
address of the Indoor Monitor to
10.1.1.113
the Subnet Mask to
255.255.255.0
and the
Default Gateway to
10.1.1.1
.
This monitor will be configured as a "Extension" Indoor Monitor.
1.
On the "Extension" Indoor Monitor, press and hold the “Settings” button for 6 seconds, then enter the
password for the Network Settings (
888888
by default).
2.5.3
Extension Indoor Monitor Configuration
3.
Select “VTH Set” and set the mode to
“Extension”. You can now set the Room
Number to the same as the Master
Indoor Monitor but add “ -1 “ to show
that it is the first extension (such as
9901-1).
4.
Enter the IP address of the “Master”
Indoor Monitor
10.1.1.112
and press
“OK” to save.
