background image

WARNING

To prevent damage to the door gasket, make sure you have the door fully open when pulling 

shelves out of the compartment.

The appliance must be positioned so that the plug is accessible.  Release the electric cord. Move 

your cabinet to its final location. Do not move your cabinet while loaded with wine as it will distort 

the body. The beverage centre should be installed in a suitable place in order to avoid touching 

the compressor with the hand.  If the supply cord is damaged, it must be replaced by an ap-

proved service agent to ensure correct installation.

Important Safety Instructions

Warning

To reduce the risk of fire, electrical shock, or injury 
when using your appliance, follow these basic pre-

cautions

• Read all instructions before using the Beverage centre

DANGER OR WARNING:

  Risk of child entrapment.  Child entrapment and suffocation are 

not problems of the past. Junked or abandoned appliances are still dangerous ... even if they 
will “just sit in the garage for a few days”

Before you throw away your old Beverage centre: 

 Take off the door, Leave the shelves in 

place so that children may not easily climb inside

• Never allow children to operate, play with, or crawl inside the appliance.

• Never clean appliance parts with flammable fluids. The fumes can create a fire hazard or ex-

plosion.

• Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or 

any other appliance.   The fumes can create a fire hazard or explosion.

>> Save these instructions <<

Installation Instructions

Before Using Your Beverage Centre

 

Remove the exterior and interior packing.

 

Before connecting the Beverage centre to the power source, let it stand upright for  

 

approximately 2 hours. this will reduce the possibility of a malfunction in the cooling  

 

system from handling during transportation.

 

Clean the interior surface with lukewarm water using a soft cloth.

Installation of your Beverage centre

 

This appliance s designed to be free standing installation or build-in (fully recessed)

Summary of Contents for v40bvc










Reviews: