•
Set the desired cooling temperature by pressing the buttons adjacent to the “Up/Down” program.
Each depression of the buttons will scroll through the available temperature settings in incre-
ments of 1 degree. The temperature selected will flash in the LED display for approximately 5
seconds, then revert back to display the temperature of the internal cabinet. The temperature
setting can be adjusted from 2 to 10 degrees.
Shelves
•
To prevent damaging the door gasket, make sure you have the door fully opened when pulling
shelves out of the compartment.
•
For easy access to the contents, you must pull the shelves approximately 1/3 out of the com-
partment, however this unit was designed with a notch on each side of the shelf tracks to prevent
bottles from falling.
•
When removing any of these shelves out of the compartment, you must first unscrew the Phillips
screws and remove both of the plastic posts which hold the shelves in place.
Note
•
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the Beverage centre will not start.
•
When you use the beverage centre for the first time or restart the beverage centre after having
been shut off for a long time, there could be a few degrees variance between the temperature
you select and the one indicated on the LED readout. This is normal and it is due to the length of
the activation time. Once the beverage centre is running for a few hours everything will be back
to normal.
Summary of Contents for v40bvc
Page 9: ......
