17
901091 REV A 3/29/12, INST 1968 CUTLASS wo AC EVAP KIT PG 17 OF 25
INSTALL DUCT HOSES AS SHOWN IN FIGURE 19, PAGE 18.
INSTALL 3/8 GROMMET.
ROUTE A/C WIRES THROUGH 3/8 GROMMET AS SHOWN ON FIGURE 17.
(12 VOLT/ GROUND/ BINARY SWITCH/ HEATER VALVE).
INSTALL CONTROL PANEL ASM.
PLUG THE WIRING HARNESS IN THE ECU MODULE ON SUB CASE AS SHOWN IN FIGURE 19, PAGE 18.
(WIRE ACCORDING TO WIRING DIAGRAM ON PAGE 19 AND 20.)
REINSTALL ALL PREVIOUSLY REMOVED ITEMS (BATTERY TRAY, BATTERY, INNER FENDER AND RADIATOR).
INSTALL GLOVE BOX IN GLOVE BOX COMPARTMENT USING OEM SCREWS. SEE FIGURE 18 BELOW.
FILL RADIATOR WITH AT LEAST A 50/50 MIXTURE OF APPROVED ANTIFREEZE AND DISTILLED WATER. IT IS THE
OWNER'S RESPONSIBILITY TO KEEP THE FREEZE PROTECTION AT THE PROPER LEVEL FOR THE CLIMATE IN
WHICH THE VEHICLE IS OPERATED. FAILURE TO FOLLOW ANTIFREEZE RECOMMENDATIONS WILL CAUSE
HEATER CORE TO CORRODE PREMATURELY AND POSSIBLY BURST IN AC MODE AND/OR FREEZING WEATHER,
VOIDING YOUR WARRANTY.
DOUBLE CHECK ALL FITTINGS, BRACKETS AND BELTS FOR TIGHTNESS.
VINTAGE AIR RECOMMENDS THAT ALL AC SYSTEMS BE SERVICED BY A CERTIFIED AUTOMOTIVE AIR
CONDITIONING TECHNICIAN.
EVACUATE THE SYSTEM FOR A MINIMUM OF 45 MINUTES PRIOR TO CHARGING AND LEAK CHECK PRIOR
TO SERVICING.
CHARGE THE SYSTEM TO THE CAPACITIES STATED ON THE INFORMATION PAGE (PAGE 4) OF THIS
INSTRUCTION MANUAL.
SEE OPERATION OF CONTROLS PROCEDURES PAGE 21.
FINAL STEPS
FIGURE 17
FIGURE 18
GLOVE BOX
496096
GROMMET
33145-VUI
