13
901091 REV A 3/29/12, INST 1968 CUTLASS wo AC EVAP KIT PG 13 OF 25
FIGURE 11
FIGURE 12
#10 A/C
HOSE
HOSE
CLAMPS
HEATER
HOSE
#6 A/C
HOSE
PRESS
TAPE
KICK PANEL
FRESH AIR
CAP
DRILL 3/16” HOLES IN
COWL AFTER LEVELING
(2) #14 x 3/4
HEX SHEET
METAL SCREW
EVAPORATOR INSTALLATION CONT.
LIFT EVAPORATOR UNIT UP UNDER THE DASHBOARD. SECURE LOOSELY TO THE FIREWALL FROM THE
ENGINE COMPARTMENT SIDE USING (2) 1/4-20 x 1 1/4 HEX BOLT AND FLAT WASHER, SEE FIGURE 12.
VERIFY THAT EVAPORATOR UNIT IS LEVEL AND SQUARE TO THE DASH.
SECURE THE FRONT EVAPORATOR MOUNTING BRACKET TO COWL. USING BRACKET AS TEMPLATE DRILL
(2) 3/16” HOLES IN COWL. SECURE WITH (2) #14 x 3/4 HEX SHEET METAL SCREWS SEE FIGURE 12 BELOW.
THEN TIGHTEN ALL MOUNTING BOLTS. (
NOTE: TIGHTEN THE BOLT ON FIREWALL FIRST, THEN THE
FRONT MOUNTING BRACKET
.)
(2) 1/4-20 x 1 1/4”
HEX BOLT
182899
(2) 1/4”
FLAT WASHER
18125-VUB
68 CUTLASS
MOUNTING
HOLES
