Vimar ELVOX SL24.T, Installer Quick Manual

Page: 9 / 28

7
SL24.T
EN
Advanced calibration
(slow-down and pedestrian distance programmed by the installer)
No. Press
push-button Step
Description
1 - Preparation Move the gate to approximately 1 metre from closing
2 PROG Procedure activation
Press the programming push-button PROG and hold it down; the PRG LED will start flashing slowly;
keep PROG pressed until the PRG LED flashes fast, and then release it
3 51 Gate closing Press pushbutton 51: the motor closes at reduced speed up to the closing limit switch
4 - Gate opening The motor opens at normal speed
5 51
Setting the slow-down
point when opening
Press 51 to set the slow-down starting point when opening the gate
6 - Completion of opening The gate continues until it reaches the opening limit switch
7 - Gate closing The motor closes at normal speed
8 51
Setting the slow-down
point when closing
Press 51 to set the slow-down starting point when closing the gate
9
- Complete closure The gate continues until it reaches the closing limit switch
10
- Gate opening The motor opens at normal speed
11
51
Setting the pedestrian
distance
Press 51 to set the pedestrian opening space
12 - Gate closing The motor closes until the closing limit switch is reached
13 - End of procedure The PRG LED turns off. End of procedure
Remote control programming
Note: Remote control programming can only be done with the automatic gate system stationary
Step-by-step programming
No. Press push-button
Signal
PRG LED
Description
1 MRX Off Press the MRX push-button and hold it down until the green PRG LED starts flashing slowly
2 Remote control push-button Slow flashing Press the remote control push-button that you want to save
3 -
Fixed 1 s Button of the saved remote control (new remote control)
3 flashes Memory full
Programming the second radio channel
No. Press push-button
Signal
PRG LED
Description
1 MRX Off Press the MRX push-button and hold it down until the green PRG LED starts flashing fast
2 Remote control push-button Fast flashing Press the remote control push-button that you want to save
3
-
Fixed 1 s Button of the saved remote control (new remote control)
3 flashes Memory full
Deleting a remote control
No. Press push-button
Signal
PRG LED
Description
1 MRX Off Press the MRX push-button and hold it down until the green PRG LED starts flashing very fast
2 Remote control push-button Very fast flashing Press the button on the remote control to delete
3 - Fixed 1 s Deletion successful
Complete deletion of the receiver
No. Press push-button
PRG LED indica-
tor
Description
1 - Off Remove power from the control panel and disconnect any batteries
2 MRX On continuously
Reapply power to the control panel without releasing the MRX button until the PRG LED turns
off
3 - Off Receiver deleted completely
After deleting all of the remote controls, the first one saved configures the control panel to accept only rolling-code or hard-coded remote
controls.