Vimar 8013406205636, Installer'S Manual

Page: 14 / 32

14
EN
69AM/T
Contents ............................................................. page
- Warnings for the installer ........................................ 14
1. General information............................................... 14
2. Electrical installation ............................................ 14
3. Hardware configuration ........................................ 16
4. Software configurations ...................................... 16 - 23
5. Operation ............................................................... 24
- Wiring diagrams ...................................................... 26 - 29
The instructions manual can be downloaded from the
website:
www.vimar.com
Installation rules
Installation must be carried out by qualified persons in compliance with
the current regulations regarding the installation of electrical equipment
in the country where the products are installed.
Regulatory compliance
EMC directive
Standards EN 60065, EN 61000-6-1 and EN 61000-6-3.
REACH (EU) Regulation no. 1907/2006 – Art.33. The product may
contain traces of lead.
WEEE - User information
The crossed bin symbol on the appliance or on its packaging
indicates that the product at the end of its life must be collected
separately from other waste. The user must therefore hand the
equipment at the end of its life cycle over to the appropriate municipal
centres for the differentiated collection of electrical and electronic waste.
As an alternative to independent management, you can deliver the
equipment you want to dispose of free of charge to the distributor when
purchasing a new appliance of an equivalent type. You can also deliver
electronic products to be disposed of that are smaller than 25 cm for free,
with no obligation to purchase, to electronics distributors with a sales
area of at least 400 m
2
. Proper sorted waste collection for subsequent
recycling, processing and environmentally conscious disposal of the
old equipment helps to prevent any possible negative impact on the
environment and human health while promoting the practice of reusing
and/or recycling materials used in manufacture.
1. General information
Art. 69AM/T is a video only switch used in the Elvox DUE FILI
VIDEO DOOR ENTRY SYSTEM for video surveillance.
Up to four cameras can be connected to the base module. Using
expansion module Art. 69AM/T4, to which up to a maximum of four
cameras can be connected at a time, the number of cameras can
be increased. Up to 3 modules Art. 69AM/T4 can be connected to
Art. 69AM/T, for a maximum of 16 cameras.
Combined with a suitably configured concierge switchboard Art.
40510, it makes it possible to set up a camera function for the
switchboard itself. In this configuration, you need to use a 69AM/T
for every switchboard and the only camera must be connected to
the V1 - MV1 input.
The 69AM/T switch cannot be used simultaneously for any other
purpose.
The maximum number of cameras according to the additional
69AM/T4 modules (Fig. 2) is indicated in the following table:
ADDITIONAL
MODULES
MAXIMUM NUMBER OF CAMERAS
0 4
1 8
2 12
3 16
2. Electrical Installation
The interface is connected to the system by means of the terminal
block CN10 located to the upper left (Fig. 1).
MARK DESCRIPTION
+ E +I of a possible auxiliary power supply unit Art.
6923, the – should be connected to M
F2 Open collector output, max 100 mA. As a
source of power supply, use +12 VDC
F1 Open collector output, max 100 mA. As a
source of power supply, use +12 VDC
12 To be used to power the loads on F1 and / or
F2. 100 mA maximum. It is only present when
at least one of F1, F2, camera, data transmis-
sion is active
M Reference ground of +I, 12, +E
+ I Active positive output max. 100 mA (+12VDC
when a camera is on).
B1, B2 Elvox Due Fili bus
Connector CN15 of the 69AM/T should be connected to the EXP.
IN of the first 69AM/T4 module. The EXP. OUT of the 69AM/
T4 should be connected to the EXP. IN of the subsequent one
and so on.
The cameras should be connected using a coaxial cable to
V1-M1, V2-M2 and so on (Fig. 3).
For the configuration of the 69AM/T4 module, see the related
instructions.