INSTALLATION INSTRUCTIONS
Converting Type 1 Pressure Regulator for Use with
LP/ Propane
1. Remove pressure regulator cap with a wrench.
2. Remove plastic insert from pressure regulator cap.
•
Plastic insert fits tightly in cap.
3. Reverse plastic insert and carefully push plastic
insert firmly into hole in pressure regulator cap.
•
Cap must show “LPG10" or “LP10".
4. Place pressure regulator cap on pressure regulator
and
tighten.
•
Insert should not disturb spring in body of
regulator.
Converting Type 2 Pressure Regulator for Use with
LP/Propane
1. Remove pressure regulator cap with a wrench.
2. Reverse pressure regulator cap.
•
Cap must show “LP”.
3. Place pressure regulator cap on pressure regulator
and
tighten.
Converting Broiler Burner for Use with LP/Propane
1. Locate orifice spud attached adjacent to pressure
regulator and remove for later use.
2. Open oven door and locate broiler burner on oven
ceiling.
•
Remove oven door to make conversion easier.
See “Removing Oven Door” section.
3. Remove screw securing front of burner to oven
ceiling and remove broiler.
•
Be careful not to damage ignitor while removing
broiler.
A--- Remove Screw B --- Broiler C --- Orifice
4. Unscrew natural gas burner spud stamped “52" with
5/16-inch socket wrench and replace with
LP/propane burner spud stamped “58".
•
Attach unused burner spud near regulator for
future use.
5. Reinstall broiler.
29