5
Installation and Specifications
A. E-30TF-IP / E-30TF-IP-EWP
The
E-30TF-IP
is designed to be flush mounted to the included 4” x 4” x 2” deep plastic rough in box or surface mounted
using an optional Viking model
VE-5x5
.
Note:
The
E-30TF-IP
will NOT mount to a standard double gang box. If your
application requires a double gang box, see Model
E-32TF-IP.
The plastic rough in box (part #
259576
) may be
purchased separately. Go to
www.vikingelectronics.com
and click on “
Spare Parts
”.
Dimensions:
Overall: 5” x 5” x 2.25” (127mm x 127mm x 57mm), Plastic Rough-In Box: 4” x 4” x 2.12” (102mm x 102mm x 57mm)
E-30TF-IP Faceplate:
14 gauge 316 stainless steel with #4 brushed finish
Shipping Weights:
E-30TF-IP:
2.12 lbs (1.0 kg)
Motion Sensor LED :
Motion sensor LED lights steady Blue to help locate the sensor in low light, flashes Green during dialing, then
lights steady Green when answered.
Note:
When European CE compliance is required, mount in optional
VE-5X5
metal enclosure.
Note:
When mounting outside to rough or uneven surfaces (brick, stucco, etc.) apply a bead of clear silicone caulking around
the top edge / sides of faceplate or
VE-5x5
.
Front View of Optional
VE-5x5 (not included)
2.25”
5.14”
5.22”
3.25”
Rear View of
VE-5x5 (not included)
5.0”
Typical
(2) 0.2 x 0.43 slots for
single gang box
(4) 0.2 x 0.43 slots for
double gang box
3.0” 3.3”
3.0”
Wall Stud
* Front View of
Plastic Rough-In
Box (included)
VIKI
NG
©
(4) 0.38” diameter
(for gooseneck
pedestal mounting)
Peel paper liner and adhere gasket
to back of panel, centering over
mounting holes.
Caution:
For rough
surfaces (ie: brick, stucco, etc.)
additional caulking may be required.
(4) T-10 Torx stainless steel,
flat head, security screws
and drive bit (included)
Optional VE-5x5 Surface Mount Box with
black satin powder paint finish, not included
(DOD 424). Optional VE-LIGHT kit can be
used to illuminate the faceplate when used
with a VE-5x5 (DOD 428).
WARNING: Do NOT use a wet location box.
Model E-30TF-IP
shown in an optional
VE-5x5 Surface
Mount Box mounted
to a VE-GNP
Gooseneck Pedestal
Other pedestal
options available,
see DOD 424
The optional
VE-5x5
Surface Mount Box
(above) is designed to be surface mounted
to a single gang box, double gang box or
VE-GNP
Gooseneck Pedestal (shown
right). For more information on the VE-5x5
and VE-GNP, see DOD 424.
|
OR
|
Motion Sensor with LED
Condensation Drain Hole
Laser Etched Graphics
4.0"
2.1”
Earth
Ground
Earth Ground the
Green/Yellow
wire using the
provided wire nut
** Wire
knock out
(2) Standard
flat head dry
wall (sheet
rock) screws
(not included)
Condensation
Drain Hole
***(2) 0.74"
diameter
