8
B. Manually Muting SIP / Network Failure Alarm Beeps
(3 beeps repeated every 30 seconds)
With the unit connected and powered (RJ45 Green LED on and Yellow LED off or blinking) it will output 3 beeps every
30 seconds and turn the Motion Sensor Blue LED on and off once per second indicating a SIP registration failure, failure
to receive an echo reply from pinged gateway or Ethernet connection failure. You can manually disable the beeps by
holding your hand over the motion sensor for 5 seconds (2 beeps will then be heard) or by clicking the “Mute Alarm
Until Next Failure” tab in the Viking VoIP programming software. The LED will continue to flash allowing you to trouble
shoot the failure.
A. Connect / Disconnect
Open the “Viking IP Programming” software on the PC and the start screen shown below will appear. Any Viking IP
phones that are connected to the network will appear on the list. Simply select the Entry Phone on the list and click on
the “Connect” button at the bottom or double click the selected phone. If the security code of the selected phone is still
set to default (845464), the PC software will not require entering a security code to connect to the phone. Entry Phone’s
have a default name of “VIKING_MK64_Vik02”, so if many phones are connected to the same network that all have
the default name, MAC addresses must be used to identify each phone.
When finished programming, click on the “Disconnect” button at the bottom. Closing the program will also automatically
disconnect the unit.
