11
Programming Features
Index
DESCRIPTION
Section
Page
Motion Sensor Sensitivity ( 1 to 4 inches, Factory set fully clockwise / 4 inches)
Features
4
Connect/Disconnect
A
9
VLAN Settings
D
11
Unit Name
1
13
SIP Server
2
13
Peer to Peer Settings
3
13
Outbound Proxy
4
13
Authentication ID
5
13
Register Fails
6
13
Speed Dial Numbers
7
14
Security code (factory set to 845464)
8
14
ID Number
9
14
Access Code (1 - 6 digits, blank = disabled, factory set to 123456)
10
14
Internal / External Relay (factory set to Internal)
11
15
Relay Mode (Door Strike, Outbound Call, In / Outbound Call, Doorbell, LV-1K Control, Ring, Ring Flash, factory set to Door Strike)
12
15
Relay Activation Command (1 or 2 digits, factory set to
)
NOTE:
Relay Mode must be set to Door Strike
13
16
Relay Activation Time (0.5 - 99 sec, factory set to 5 seconds)
14
16
Relay Buzz Volume (1 - 3 or Disabled, factory set to 3)
15
16
Relay Latch Commands (Enabled or Disabled, factory set to Enabled)
NOTE:
Relay Mode must be set to Door Strike
16
16
Alternating Switch Action
17
16
Speaker Mode (ON, OFF / Silent Monitor or OFF until Answered, factory set to ON)
18
16
Speaker Volume (0 - 9, factory set to 3)
19
16
Ring Volume (0 - 9, factory set to 5)
20
16
Microphone Volume (0 - 9, 0 = Auto, factory set to 5)
21
17
Talk/Listen Delay (VOX) (0.1 - 0.9 seconds, factory set to 0.5 seconds)
22
17
In-Band Audio Call Progress (Enabled, Disabled, factory set to Enabled)
23
17
In-Band Audio Detect Sensitivity (1 - 9, 1 = minimum, 9 = maximum, factory set to 5, power cycle unit after setting)
24
17
Lap Counter (1 - 9 or Disabled, factory set to Disabled)
25
17
Call Length Time Out (disabled or 1 - 9 minutes, factory set to 3 minutes)
26
17
Inbound Call Mode (Disabled, Auto Answer, Auto Answer-Secure, Ring, Ring with AGC, factory set to Auto Answer)
27
18
Ring Cadence (factorty set to Normal, 2 seconds on 4 seconds off)
28
18
Dial Next Number on RNA (Ring No Answer) (disabled, 1 - 9 = number of rings, factory set to 7)
29
18
Dial Next Number on Busy (disabled or enabled, factory set to Enabled)
30
18
Send ID Numbers as (RFC 2833 or In Band DTMF, factory set to RFC 2833)
31
18
Call LED Mode (OFF, Entry Phone, Emergency Phone or Emergency Outbound only, factory set to Entry Phone)
32
19
Call LED Control (Automatic or enter
Q
to light, factory set to Automatic)
33
19
Mute Current / Next Alarm
34
19
Permanent Alarm Mute (factory set to Alarm Tones Enabled)
35
20
IP Firmware
36
20
Unit Firmware
37
20
Import/Export
38
20
Clear Unit Settings
39
20
Clear IP Settings
40
20
Diagnostics (used to check mic, speaker and relay operations)
41
20
REX Input
42
20
