V-Tap ISDN BRI Manual EN v2.6 Dec 2018 © 2017-2018 Vidicode 21
3.3.8
Button Mode setting
The button can be used to manually start and stop recording calls. Other
special functions of the button are described in chapter
Button functions
Button Mode: 1=Start 2=Stop
Manual recording with the button is enabled when this setting is other
than zero. Manually starting and stopping is used when one phone is
connected and the user can press the button on the V-Tap.
The following values can be entered:
1 = Start mode. Each call starts with the Red LED OFF (not recording).
The user must press the button before or during the call to save
the recorded data. Non-saved calls are deleted from the SD card.
2 = Stop mode. Each call starts with the Red LED ON (recording).
The user must press the button before or during the call to cancel
saving of the data. Non-saved calls are deleted from the SD card.
3 = Manual Start-Stop mode. Each time when the button is pressed
during a call, a recorder file is opened or closed on the SD card.
After power on, the Red LED is OFF, so the V-Tap is not recording.
mode + 4 = When 4 is added to mode, the V-
Tap is in ‘pre
-
recording’
mode, meaning that all audio of all calls is always stored, even after
stopping with the button. Normally, the audio storage is stopped or
started when the button is pressed. The decision to keep or delete the
recording is made at the end of each call, depending on the state of the
Red LED at that time. One advantage is, that the user can press the
button in the
middle of a call to ‘start’ it and then the complete call
from the beginning is saved.
mode + 8 = The non-saved calls are kept on the SD card, but are NOT
sent to the Tunnel server. Keeping these files can be used for safety
reasons, giving the possibility to retrieve them later. These files have a
different file name and are only deleted from the card when
overwritten or by the “SD Delete File after Sending” function.
Watch the Red LED: ON=Started , OFF=Stopped
