67009600-EN - Edition 2015 - Rev. 1.0
55
VX2300 Digital System - “2 Wire” Audio/Video Door Entry System
VX2300 Digital System - Installation handbook
Kristallo Series
3.5" Flush and surface videomonitor wall mounting instructions
FLUSH MOUNT KRISTALLO VIDEOPHONE
1. Protect the holes to fix the videophone to the flush mounting box then embed the flush mounting box in line with the wall in a
vertical position at 135cm height from the floor as shown in
figure 1.
2. As shown in
figure 2,
connect the wires using a flat screw driver then setup the dip-switches as per provided connection diagram
or instruction sheet.
3. As shown in
figure 3,
once the wires are connected, fix the videophone to the flush mounting box using a Phillips screwdriver
and the two screws provided.
In order to avoid malfunctions, please do not over tighten the fixing screws shown in figure 3.
4. Once the videophone is fixed to the flush mounting box, place the front plate against the videophone by inserting the hooks in
the corresponding openings and hook the plate by pushing it down as shown in
figure 4
.
5. Test the system for correct operation.
SURFACE MOUNT KRISTALLO VIDEOPHONE
1. As shown in figure 1a, place the videophone against the wall at 135cm height from the floor and mark the fixing holes. Make the
holes (5mm diameter) and insert the provided wall plugs as shown in
figure 1b.
2. As shown in
figure 2a,
connect the wires using a flat screw driver then setup the dip-switches as per provided connection dia-
gram or instruction sheet.
3. As shown in
figure 3a,
once the wires are connected, fix the videophone to the wall using a Phillips screwdriver and the two
screws provided.
In order to avoid malfunctions, please do not over tighten the fixing screws shown in figure 3a.
4. Once the videophone is fixed to the wall, place the front plate against the videophone by inserting the hooks in the correspond-
ing openings and hook the plate by pushing it down as shown in
figure 4a
and hang the handset as shown in
figure 4b.
5. Test the system for correct operation.
TOUCH SENSITIVE KEYS ADJUSTMENT
Cleansing the panel with the plate on or removing the plate for any reason may cause the touch sensitive buttons to lose their ad-
justment. If you detect any malfunctions, we suggest you proceed as follows:
• Remove the front plate doing the contrary of what is shown in
figure 4a
and
4a
;
• Touch the touch sensitive button area (the first of the three areas aligned in horizontal way from the right side)until the display
turns on (about 5 seconds);
• Touch the touch sensitive
button area repeatedly until the pointer is on “EXIT”;
• Hang up the front plate as shown in picture
figure 4a
and
4a
; before the display turns off;
• When the display turns off the setting is done and the system is ready for use.
