Videx VX2300, Installation Handbook

Page: 42 / 100

67009600-EN - Edition 2015 - Rev. 1.0
42
VX2300 Digital System - “2 Wire” Audio/Video Door Entry System
VX2300 Digital System - Installation handbook
1. In order to install the videophone, it is necessary to remove the cover, which contains all the electronics, from the base: press
lightly on the bottom part of the videophone and simultaneously pulling outwards the upper part as shown in
Fig. 1
.
2. Put the base of the unit on the wall at approx 135cm from the finished floor to match the points for the fixing holes
“A”
(
Fig. 2
)
remembering that the wires
“D”
(
Fig. 3
) must be fed through the large hole
“E”
(
Fig. 3
). If you use the flush mounting box 503,
embed it into the wall vertically at approx. 140cm from the finished floor and the base.
3. Following
Fig. 3
, make the holes
“A”
, insert the wall plugs
“B”
and fix the base with the screws
“C”
feeding the wires
“D”
through the hole
“E”
. If you have used the box 503, fix the base to the wall through the holes
“F”
using the screws
“C”
.
4. As shown in
Fig. 4
, connect the wires to the removable terminals following the provided installation diagram. Connect the terminal
blocks to the electronics contained in the cover as shown in
Fig. 5
. Test system before closing.
Contrast and hue trimmers can be adjusted only if the videophone is open. To activate the display and see changes use the
“Camera Recall” function by pressing
button
.
Note: while testing the system, it is advisable to hold the cover with your hand.
5. Once testing is complete and all the necessary adjustments are made, close the unit as shown in
Fig. 6
: first hook in the bottom
and the then the top until you hear a click.
1
2
Fig. 1
Fig. 4
135cm
Fig. 2
Fig. 5
A
B
A
B
D
C
F
F
E
C
Fig. 3
1
2
Fig. 6
6300 Series
Wall mounting instructions