ENUK - V1.0 - 08/06/18
- 7 -
Kristallo Series
Art. KR-AV-VR - Installation Instructions
SURFACE BACK BOX INSTALLATION (KR-AV-VR-SB)
130 - 160cm
A
A
C
D
B
E
A
Fig. 12
Fig. 13
Fig. 14
O
N
O
N
Torx pin key
Fig. 15
Fig. 16
1. The surface box
should be mounted to the wall at a height of approximately 130-160cm from the floor level to the centre of
the camera lens of the
KR-AV-VR
panel,
Fig.12
. Place the surface box
against the wall and mark the 4 fixing holes
for the
wall plugs
and the hole for the cables
, see
Fig.14
;
In order to prevent water ingress we highly recommend using a silicon sealant between the wall and the surface box
, ON THE LEFT, TOP AND RIGHT SIDES ONLY AND ENSURE ALL THE CABLE ENTRY HOLES ARE SEALED. DON'T USE
SILICON SEALANT ON THE BOTTOM SIDE OF THE BACK BOX (Fig.13);
2. Drill the 4 fixing holes
, insert the wall plugs
and feed the cables through the surface box knockout required. Fix the surface
box to the wall using self-tapping masonry screws
, see
Fig.14
, remember to allow room for the connecting cables;
3. Feed the connecting cables through the knockouts required in the surface box (see
Fig.15
) and make all necessary connections
between the cable and the
KR-AV-VR
panel following the wiring diagram on page 9. Connect the earth strap as described on page
5 (also refer to
Fig.6)
;
4. Make any other necessary panel adjustments required (dip-switch settings, speech volume adjustments etc.). After the system has
been tested and is working correctly place the
KR-AV-VR
panel back into the surface box and fix it using the screwdriver (using the
torx end) or torx pin key provided and the torx pin security screws (see
Fig.16
).
Note: do not over tighten the screws more than
is necessary.
Art. KR-AV-VR
Vandal Resistant Digital A/V Door Panel for VX2200
