ENUK - V1.0 - 08/06/18
- 6 -
Art. KR-AV-VR - Installation Instructions
Kristallo Series
FLUSH BACK BOX INSTALLATION (VRFB100X270)
130 - 160cm
w
h
d
Fig. 7
Fig. 8
Fig. 9
O
N
O
N
Torx pin key
Fig. 10
Fig. 11
1. The flush back box should be flushed into the wall. It is recommended that the
KR-AV-VR
panel is fitted at a height of approx.
130-160cm from the floor level to the centre of the camera lens, see
Fig.7
;
2. Using the flush box and the hole dimensions:
VRFB100x270 (w=80mm x h=270mm x d=40mm)
,
Fig.8
, use appropriate tools to cut
out the recommended hole size in the wall (where necessary wear the appropriate protective clothing when doing this). Remember
to allow room for the connecting cables;
In order to prevent water ingress we highly recommend using a silicon sealant between the wall and the flush box, ON
THE LEFT, TOP AND RIGHT SIDES ONLY AND ENSURE ALL THE CABLE ENTRY HOLES ARE SEALED. DON'T USE SILICON
SEALANT ON THE BOTTOM SIDE OF THE BACK BOX (Fig.9);
3. Embed the flush box into the wall. Feed the connecting cables through the knockouts required in the flush box (see
Fig.10
) and
make all necessary connections between the cable and the
KR-AV-VR
panel following the wiring diagram on page 9. Connect the
earth strap as described on page 5 (also refer to
Fig.6)
;
4. Make any other necessary panel adjustments required (dip-switch settings, speech volume adjustments etc.). After the system has
been tested and is working correctly place the
KR-AV-VR
panel back into the flush box and fix it using the screwdriver (using the
torx end) or torx pin key provided and the torx pin security screws (see
Fig.11
).
Note: do not over tighten the screws more than
is necessary.
Art. KR-AV-VR
Vandal Resistant Digital A/V Door Panel for VX2200
