25H/SP/DDA/2W - TECHNICAL MANUAL
EN-UK - V.1.2 - 04/01/16
35
VIDEX
25H/SP/DDA/2W
(1 way “2 wire” DDA audio intercom kit)
RESETTING THE ART.UIM-138 DISPLAY MODULE
The Art.UIM-138 display module can be reset back to
factory default by following the steps below:
1. First make sure that the UIM-138 display is still
connected to the 138N speaker amp with the
5 pin connector.
2. Disconnect the 12Vdc power from the 138N
speaker amp.
3. Link out terminals 0V and I5 on the UIM-138
display module.
4. Reconnect the 12Vdc power back onto the
138N speaker amp.
5. The display will re-initialize. First it will display
the part number and firmware version as
shown in Fig.12.
6. Next it will show ‘PLEASE WAIT’ along the top
line and the progress bar along the bottom
line of the display as shown in Fig.13.
7. Once the display shows ‘OK’, as shown in
Fig.14, remove the link between 0V and I5. The
settings in the UIM-138 display module will be
returned back to factory default.
VIDEX UIM-138
R:1.0 (138N:1.3)
PLEASE WAIT
. . . . . .
OK
QUICK USB DRIVER SETUP GUIDE
1. Insert the 2X00PC software CD into the PCs CD/DVD rom drive.
2. Select ‘RUN’ from the start menu.
3. Type in ‘D:\CDM20824_Setup.exe’ then press the ‘OK’ button.
4. The relevant driver for the USB cable will be installed.
Fig.12
Fig.13
Fig.14
QUICK SOFTWARE SETUP GUIDE
1. Insert the 2X00PC software CD into the PCs CD/DVD rom drive.
2. Select ‘RUN’ from the start menu.
3. Type in ‘D:\setup’ then press the ‘OK’ button.
4. Follow the on screen instructions to complete the setup.
5. Connect the USB cable between the PC and the UIM-138 display module.
6. Once the Programmer software setup is complete ‘double click’ on the programmer desktop icon
to launch the software.
