25H/SP/DDA/2W - TECHNICAL MANUAL
EN-UK - V.1.2 - 04/01/16
24
VIDEX
25H/SP/DDA/2W
(1 way “2 wire” DDA audio intercom kit)
From the top menu on the main programmer screen when ‘Communication’
is selected the following drop down menu will appear, as shown below.
From the drop down list the following options are available:
• Comm Port -
selecting this option from the drop
down menu will allow an available COM port to be
selected
(please note that when the programmer
software loads up it will automatically detect if a
UIM-138 display is connected and automatically
select the COM port).
• Refresh List -
selecting this option from the drop down menu will refresh the COM port drop down list
(please note that the COM port that the UIM-138 display is connected to will be included in the COM port drop
down list if it hasn’t already been included when the programmer software first launched).
• Check Connection -
selecting this option from the drop down menu will check and refresh the COM port
connection between the programmer software and the UIM-138 display module.
• Manually Connect -
although shown in the drop down list this option is not applicable.
The baud rate 9600 will already be selected and all options greyed out.
(When the programmer software first
loads up it will automatically check through the COM ports, searching under different baud rates to see if the UIM-
138 display is connected).
This option confirms the current version of programming software being used.
The bottom of the main programmer screen indicates the current status of the programmer software and
its connection to the UIM-138 display module. The following notes describe the different statuses the
programmer software will show.
Upload
Baud
About
THE STATUS AND PROGRESS BAR
• Not Detected -
this status is shown when the programmer software hasn’t detected a device
(UIM-138
display module)
attached to the PC, as shown below.
The ‘Refresh List’ option can be selected from the ‘Communication’ drop down list
(from the top menu)
and the status bar will confirm that the ports list has been updated, this can be seen to the right of the
progress bar as shown below.
