ANTIVANDAL OUTDOOR IP SPEED DOME CAMERA /
MPEG4 with Motion Tracking
19/95
Alarm Input Connections
Sensor Input
Before connecting sensors, check driving voltage and output signal type of the sensor. Since output
signal types of the sensors are divided into Open Collector and Voltage Output type in general, the
cabling must be done properly after considering these typed.
Signal
Description
IN #+
Connect (+) cable of electric power source for Sensors to this port as
shown in the circuit above. Allowable voltage is 5 ~ 12 Volts DC.
GND
Common to all 8 Sensor input.
* NOTE: Type of sensor is fixed to NO type (Normally Open).
Sensor Out
* NOTE: As shown in the drawing, you can change the type of Relay Out (NC or NO) by shifting the
jumpers near by terminal blocks of Alarm Outputs.
INSTALLATION
2
