34
Instruments, Features and Controls
Brakes
Rear Brake Pedal
The rear brake pedal is located on the right side
of the motorcycle. Press downward on the rear
brake pedal to apply the rear brake.
The rear brake pedal activates the rear brake cal-
iper fully while simultaneously activating one of
the three pistons in each front brake caliper.
See page 34 for pedal adjustment options.
See page 51 for braking procedures.
Gear Shift Pedal
The gear shift pedal is located on the left side of
the motorcycle.
• Press downward on the gear shift pedal to
shift to a lower gear.
• Lift up on the gear shift pedal to shift to a
higher gear.
See page 34 for pedal adjustment options. See
pages 50-51 for gear shifting procedures.
Pedal Adjustment
The brake pedal and gear shift pedal controls
can be adjusted to a front, rear or center position. The center
position is the factory setting.
Tip:
An accessory linkage rod is needed to fully adjust the gear shift
pedal control.
1. Remove the screw from the footwell support.
Tool:
6 mm Allen wrench
2. Slide the control forward or rearward in its track until
the threaded hole of the control aligns with the desired
hole in the footrest support.
3. Reinstall the screw.
Torque: 96 in-lbs (11 Nm)
4. After adjusting the shift pedal, always readjust the shift
linkage rod. Loosen both jam nuts on the linkage and
turn the shaft until the footpeg is about 90 mm from the
floorboard (or to desired height). Tighten both jam nuts.
Torque: 96 in-lbs (11 Nm)
Rear Brake Pedal
Gear Shift Pedal
Center Adjustment
Position
