VE46 Pipe Roll Grooving Tool
3
OPERATOR SAFETY INSTRUCTIONS
The VE46 is designed only for roll grooving
pipe. Use of this tool requires dexterity and
mechanical skills, as well as sound safety
habits. Although this tool is manufactured for
safe, dependable operation, it is impossible
to anticipate all the combinations of circum-
stances that could result in an accident. The
following instructions are recommended for
safe operation of this tool. The operator is cau-
tioned to always practice “safety first” during
each phase of use, including setup and main-
tenance. It is the responsibility of the owner,
lessee, or user of this tool to ensure that all op-
erators read this manual and fully understand
the operation of this tool.
Read this manual before operating or servic-
ing the tool. Become familiar with the tool’s
operations, applications, and limitations. Be
particularly aware of its specific hazards.
Store this manual in a clean area where it is al-
ways readily available. Additional copies of
this manual are available upon request
through the Victaulic Tool Company.
GENERAL
1.
This tool is designed ONLY for roll
grooving pipe sizes, materials, and wall
thicknesses listed in the "Tool Ratings"
section, starting on page 29.
2.
Inspect the equipment.
Before using
the tool, check all moveable parts for any
obstructions. Make sure tool components are
installed and adjusted properly.
3.
Wear proper apparel.
Do not wear loose
clothing, jewelry, or anything that can become
entangled in moving parts.
4.
Wear protective items when working
with tools.
Always wear safety glasses,
hardhat, and foot protection. Wear hearing
protection when using power-driven tools.
5.
Stay alert.
Do not operate the tool if you
are drowsy from medication or fatigue. Avoid
horseplay around the equipment.
6.
Keep visitors away from the immedi-
ate work area.
All visitors should be kept a
safe distance from the equipment at all times.
When using the tool at elevated locations as
an “In-Place” groover, the area below must
remain clear of other personnel to prevent in-
juries in case a tool or hand crank is acciden-
tally dropped.
7.
Keep work areas clean.
Keep the work
area around the tool clear of any obstructions
that could limit the movement of the operator.
Clean up any oil or other spills.
8.
Secure the pipe before performing the
grooving operation.
Make sure the pipe is
secured or otherwise capable of handling the
weight of the tool and resisting the torque
created when used as an “In-Place” groover.
9.
Keep hands and tools away from
grooving rolls during the grooving opera-
tion.
Grooving rolls can crush or cut fingers
and hands.
10.
Do not reach inside the pipe end dur-
ing tool operation.
11.
Do not force the tool.
Do not force the
tool or accessories to perform any functions
beyond their capabilities. Do not overload the
tool.
12.
Do not operate the tool at speeds
exceeding those specified in this manual.
13.
Maintain tools with care.
Keep tools
clean at all times to ensure proper and safe
performance. Follow the instructions for lubri-
cating tool components.
14.
When tools are not in use, store them
in a dry, secure place.
15.
Use only Victaulic replacement parts
and accessories.
Use of any other parts may
result in a voided warranty, improper opera-
tion, and hazardous situations. Refer to the
“Parts Ordering Information” and "Accesso-
ries" section on page 26.
16.
Do not remove any labels from the
tool.
Replace any damaged or worn labels.
TM-VE46 1924 Rev_B.fm Page 3 Wednesday, January 19, 2005 8:59 AM
