12
VE46 Pipe Roll Grooving Tool
7.
Orient the VE46 tool so that the roll arm is
located in the 6 o’clock position. Align the flat
portions of the drive shaft with the chuck jaws
by turning the drive shaft. Install the tool as-
sembly onto the power drive by inserting the
drive shaft into the chuck and engaging the
forks of the mounting plate with the tubular
support arms of the power drive, as shown
above.
NOTE:
The forks of the mounting plate
should be approximately 4 inches (100 mm)
back from the ends of the tubular support
arms, as shown above.
8.
Tighten the chuck. Make sure the chuck
jaws engage with the flats of the drive shaft.
9.
Make sure the switch on the power drive
is in the “OFF” position. Plug the power drive
into an internally grounded electrical outlet.
The outlet must meet the requirements for the
DANGER
• To reduce the risk of electric
shock, check the electrical
source for proper grounding
and follow all instructions.
• Before performing any mainte-
nance on the tool, turn the
switch on the power drive to the
“OFF” position, or disconnect
the power cord from the electri-
cal source.
Failure to follow these instructions could result in
death or serious personal injury.
TM-VE46 1924 Rev_B.fm Page 12 Wednesday, January 19, 2005 8:59 AM
