Installation
|
2-7
Surveyor MKII HD Network Dome
Components
All Surveyor MKII units are comprised of a Housing, a Camera Drive, a
Shroud and a Lower Dome. These components may be packed in separate
boxes within the main box.
Housing
The housing for the Surveyor MKII outdoor pendant configuration has a die-
cast aluminum housing with a sunshield. The housing has a 1.5-inch NPT
pipe flange mount. In addition, the housing is equipped with a safety cord and
clip that is used to suspend the camera drive during installation. Another
safety cord connects the lower dome to the housing. A customer interface
board, that can be unlatched or removed for easy access, is installed in the
top of the enclosure. All wiring is done to this board.
Camera Drive
The camera drive is comprised of an integral camera, pan-and-tilt drive and
CPU. It is designed for easy “snap-in” installation into the housing. The
camera drive quickly and accurately positions the camera in 360
°
of pan
angle and 90
°
of tilt angle. An additional processor-controlled heater is
provided for temperature control on outdoor units.
Shroud
The shroud is a 5.4 in. (137 mm) textured black ABS plastic shell. It has a
1.4 in. (35.6 mm) slotted opening for the camera. This shroud conceals the
position of the camera and snaps onto the camera drive.
Lower Dome
The lower dome is an assembly comprised of a 5.98 inch (152 mm) diameter
acrylic plastic shell, a trim ring and a safety cord. Standard outdoor lower
domes are clear and use 4 screws for additional support. The lower dome is
anchored to the housing by the safety cord. Refer to the Maintenance section
for care.
Sunshield
The sunshield is pre-installed over the housing used on the outdoor/high-
impact pendant version to minimize the effects of solar radiation.
Caution
For any environment subject to moisture, use the outdoor pendant model.